Installation; Installation Site; Installing The Receivers; Installing The Transmitter - BADU JET Wireless Control II Traducción De Las Instrucciones Para El Manejo Originales

5

Installation

5.1

Installation site

5.1.1

Installing the receivers

Both receivers are installed in an area outside the protection area
2.
The 2-channel receiver must be installed additionally in a switch
box.
5.1.2

Installing the transmitter

The transmitter is for hand-held operation but can be mounted on
the wall using the included wall rail.
5.2 Installation
5.2.1

Mounting the receiver

The housing can be mounted on the wall by means of the holes in
the housing. The holes are visible when the housing is opened.
Screws and plugs are included.
5.2.2

Mounting the remote control unit holder

The silver wall rail of the remote control unit can be mounted on
the wall using plugs and screws (included) if necessary. The
remote control unit can then be pushed into the holder and
screwed on if necessary. The fourth button from the bottom must
be removed for this. The button can be reinserted after tightening
the screw.
NOTE
The screw for mounting the remote control unit should only be
turned into the stop.
Fig. 4
06|2020
Installation
EN 13