Coupling To Countercurrent Systems With Massage Station - Version With Narrow, Side-Plugged Board; Coupling The Badu Jet Wireless Control Ii To A Badu Countercurrent System With Square Board - BADU JET Wireless Control II Traducción De Las Instrucciones Para El Manejo Originales

Installation
5.3.4 Coupling to countercurrent systems with massage station –
version with narrow, side-plugged board
The 2-channel receiver is used in versions with a massage
station.
The wiring remains the same as described in the previous
chapter.
The button is used to switch over the massage ball valve.
5.3.5 Coupling the BADU JET Wireless Control II to a
BADU countercurrent system with square board
The 4 -channel receiver must be used if the radio function is
retrofitted to earlier versions of counter current systems with a
square board. This is located in its own, separate housing and
can be mounted directly next to the actual switch box of the
countercurrent system.
See the countercurrent system operating instructions in chapter
5.3 for the schematic diagram of the square board.
The receiver must be wired according to the following diagram. A
prepared terminal can be found on the board. In addition, a cable
in the 4-channel receiver and a distributor terminal for L are
included.
Abb. 7
16 EN 06|2020