Relay Contacts Of The 4-Channel Receiver; Relay Contacts Of The 2-Channel Receiver - BADU JET Wireless Control II Traducción De Las Instrucciones Para El Manejo Originales

Installation
5.3.7

Relay contacts of the 4-channel receiver

The relay contacts in the receiver are potential-free. This must be
considered for the wiring. There are four changeover contacts
here which change the contact position when a radio command is
given. The LED assigned to the relay indicates the switching
status. The LED flashes in timer mode.
 The contacts may only be loaded with the values specified in
the "Technical Data" chapter.
The contacts for coupling the remote control unit to a
countercurrent system with square board are pre-specified. These
can be used individually for other applications.
5.3.8

Relay contacts of the 2-channel receiver

The relay contacts in the receiver are potential-free. This must be
considered for the wiring. There are two open contacts here which
close when a radio command is given. The LED assigned to the
relay indicates the switching status.
 The contacts may only be loaded with the values specified in
the "Technical Data" chapter.
The contacts for coupling the remote control unit to a
countercurrent system with narrow, side-plugged board are pre-
specified. These can be used individually for other applications.
18 EN 06|2020