Tripp-Lite B127A-002-BH Manual Del Propietário página 16

Installation
3. Optional: For extended range, connect up to four
B127A-010-H signal repeater units between splitter and
each receiver via Cat6 cabling.
4a. Optional for B127A-004-BHPH3: Using an HDMI 2.0
cable (such as Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series cables), connect a local monitor to
the LOCAL OUT port on the B127A-004-BHPH3 local
splitter unit. The LOCAL (orange) LED will illuminate to
indicate a display has been connected to the local port.
Note: The HDMI local display port only supports 4K/60Hz
resolutions and will not work properly with lesser resolutions.
or
4b. Optional for B127A-004-BHPH3: Cascade an additional
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat steps
4 and 5 below as necessary.
5. Using Cat6 cable (such as Tripp Lite N202-Series 24 AWG
Cat6 Cabling), connect the RJ45 port on the local splitter
unit to the RJ45 port on the remote receiver unit.
6. Using an HDMI 2.0 cable (such as Tripp Lite
P569-XXX-CERT or P568-XXX-2A Series cables), connect
the remote receiver unit's HDMI port to a monitor.
7. Turn on the power to your connected TVs/monitors. The
LOCAL (orange) LED will illuminate to indicate the local
port has been connected to a display.
16