Tripp-Lite B127A-002-BH Manual Del Propietário página 20

Installation
1. Make sure all equipment in the installation—such as TVs,
Blu-ray players and the transmitter—is powered OFF.
2. Using an HDMI 2.0 cable (such as Tripp Lite
P569-XXX-CERT or P568-XXX-2A Series cables), connect
the HDMI source to the INPUT port on the local splitter unit.
3. Optional: For extended range, connect up to eight
B127A-010-H signal repeater units between splitter and
each receiver via Cat6 cabling.
4a. Optional for B127A-008-BH: Using an HDMI 2.0 cable
(such as Tripp Lite P569-XXX-CERT or P568-XXX-2A
Series cables), connect a local monitor to the LOCALOUT
port on the B127A-008-BH local splitter unit. The LOCAL
(orange) LED will illuminate to indicate a display has been
connected to the local port.
or
4b. Optional for B127A-008-BH: Cascade an additional
B127A-002-BH, B127A-004-BH or B127A-008-BH splitter
unit via the local HDMI port (sold separately). Repeat
steps 4 and 5 below as necessary.
Note: The HDMI local display port only supports 4K/60Hz
resolutions and will not work properly with lesser resolutions.
5. Using Cat6 cable (such as Tripp Lite N202-Series 24AWG
Cat6 Cabling), connect the RJ45 port on the local splitter
unit to the RJ45 port on the remote receiver unit.
6. Using an HDMI 2.0 cable (such as Tripp Lite
P569-XXX-CERT or P568-XXX-2A Series cables), connect
the remote receiver unit's HDMI port to a monitor.
20