User Menu - FRECAN FLOW 53 Manual De Instalación Y De Usuario

Operation
During after-run the F is not shown. It pops up again when the
hob is switched on. The filter display can either be
acknowledged or reset:

Short press on fan power setting display means
acknowledgment.
Display appears only after switching the hob off and on
again.

Long press for 3 sec causes time reset.
A confirmation tone will appear and the F will be
displayed statically for 2 sec before the standard
display returns.

5.31 User menu

User menu is intended for end customer to adapt the Touch
Control to his personal needs. The available items are
described in the table below.
1. Precondition: the hob is switched off.
Touch ON/OFFkey to power up the Touch Control. Touch
the ON/OFF key again within 3 sec to set the Touch Control
to standby mode again.
2. Pause key starts pulsating (for 60 sec max). The menu is
automatically exited after that.
3. Press and hold down pulsating Pause key and press all
cooking zone in clockwise direction as shown, starting with
the left front cooking zone. User menu is active. The rear left
cooking zone display shows the selected user menu
section.
4. Select the menu item which you want to display/change via
the slider control. The value for the selected item is
displayed on the front left cooking zone display.
5. To change the menu item's value, select the menu item
value by touching the front left cooking zone. The selected
menu item value is displayed by full brightness; the other
displays are dimmed down. Choose the menu item's value
by the slider control via direct selection.
6. To exit the User Menu touch the power key for 2 seconds.
The User meu will be exited. The changes will be saved.
EN
34