Wire Clone; Keypad Lock; Menu Setting; Voi Function - Dynascan V-440 Manual De Instrucciones

Transceptor portatil fm vhf para radioaficionados
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.16.- WIRE CLONE:

Without other equipment, you can clone the data of a transceiver to other
transceiver by wire. Connect the two transceivers with the cloning cable.
Press the [MONI] key in the host transceiver while turning on, the LCD will
display "CLONE" and the status indicator LED will flash red, then the clone
process begins. If the cloning process fail, the LCD will display "ERROR".
If cloning is finishes, the LCD will display "END", and it will return to
standby state of cloning. Press any key to exit from cloning mode..

6.17.- KEYPAD LOCK:

This function is to prevent unintended use of the transceiver.
To lock the keypad:
Press [FUN] key for 2 seconds, the transceiverPulse la tecla [FUN] durante 2 segundos, the
transceiver beeps indicating that the keypad has been locked and it will display icon "
".
To unlock the keypad:
Press [FUN] key for 2 seconds, the transceiver beeps indicating that the keypad has been unlocked
and the icon will disappear.

7.- MENU SETTING:

7.1.- VOI FUNCTION:

1.- Press [FUN] key, then use the [UP] / [DOWN] keys or turn the channel
knob until display the menu 1, the LCD will display "VOI 01?"
2.- Press [PTT] to enter the menu, use the [UP] / [DOWN] or turn the
channel knob to select "CH", "ON" or "OFF" (Chinese, English or Off).
3.- Press [PTT] to confirm the setting of "VOI" (voice message) function and return to the main
menu. Press [FUN] key to save the changes and exit to main menu.

7.2.- HIGH/LOW POWER:

With high power settings more energy is consumed, so for a small communication coverage choose
the low power, but if you need a wider coverage, select the high power setting.
1.- Press [FUN] key to access the main menu, then use the [UP] / [DOWN]
keys or turn the channel knob until display the menu 2, the LCD will
display "POW 02?".
2.- Press [PTT] to enter the menu, use the [UP] / [DOWN] keys or turn the
channel knob to select "H" (high power) or "L" (low power), then press the [PTT] to confirm the
settings and return to the main menu. Low power is indicated by "LO", while the high power will
not be indicated. Press the [FUN] key to save the changes and exit to main menu (the original
setting is "H").

7.3.- SQUELCH:

1.- Press [FUN] key to access the main menu, use the [UP] / [DOWN] keys
or turn the channel knob until display the menu 3, the LCD will display
"SQL 03?".
English - 14 -

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Dynascan V-440

Tabla de contenido