Descargar Imprimir esta página

Mopar 82212502 Instrucciones De Montaje página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

61. Turn the connectors (1, 3) and remove them from the
license plate lamps (2).
62. Press the tab on each lamp and remove from the car­
rier.
63. Pay attention to the routing of the license plate lamps
wiring (4) and remove the wiring from the carrier.
NOTE: The connector (1) from the backup camera
wiring harness (2) will not be used for the license
plate lamps. The existing connector must be used,
and the connector (1) from the backup camera wiring
harness (2) must be secured out of the way.
64. Install the license plate lamps (2) to the new carrier
which has the backup camera installed.
65. Insert the lamp connectors (1, 3) to the lamps and turn
to secure them.
66. Route the license plate lamps wiring (4) the same way
as it was removed from the old carrier.
Jun 30, 2011
All manuals and user guides at all-guides.com
13
K6861197

Publicidad

loading