18
84. Position the center bezel (1) over the instrument panel
and press firmly and evenly around the perimeter of
the bezel to seat the retaining clips.
NOTE: Routing under the I/P should be above the
brake pedal sled and secured to eliminate possible
interference with all pedal movement.
under the kick panel should be secured to eliminate
possible interference with all pedal movement.
85. Route the backup camera wire harness from under the
LH side of the I/P (above the brake pedal sled) behind
the LF kick panel and secure to the vehicle harness
with tie straps.
86. Route the backup camera wire harness (4) with the
vehicle wiring harness (2) under the edge of the carpet
(1) below the LF door scuff plate and below the Bpillar
lower trim (3). Attach to the vehicle wiring harness (2)
with tie straps where necessary.
87. Route the backup camera wire harness (4) under the
edge of the carpet (1) below the sliding door scuff plate
and around the edge of the second row seat (3) to be
routed under the quarter trim panel. Attach to the vehi
cle wiring harness (2) with tie straps where necessary.
Jun 30, 2011
All manuals and user guides at all-guides.com
Routing
K6861197