Publicidad
Idiomas disponibles
Idiomas disponibles
20
91. Separate the upper and lower grommets (1, 2) from
the body holes.
92. Route the camera wiring harness through both grom
mets. Once the harness is through, seat the grom
mets in their original locations.
93. Route the rear camera harness (2) along the existing
harness and secure with tie straps.
94. Install the connector (1) as shown in the next steps.
95. Back out the connector terminal locking tab from the
backup camera connector.
96. Insert the backup camera harness wires into backup
camera connector as follows:
a. 12V ignition power wire (PK/YL) cavity 2
b. Signal return wire (DG/OR) cavity 3
c. Signal wire (DG/BR) cavity 4
d. Shield wire (DG/WT) cavity 7
e. Ground wire (BK) cavity 8
Jun 30, 2011
All manuals and user guides at all-guides.com
K6861197
Publicidad
