Mopar 82212502 Instrucciones De Montaje página 9

NOTE: Do not remove the retainer (2). When prying,
the retainer (2) will "snap" to the unlocked position.
36. If equipped, using an appropriate flat­bladed tool, pry
the plastic retainer (2) up to release the locking mech­
anism from the head of the power liftgate link rod (1).
37. Remove the link rod (1) end from the liftgate by gently
pulling the link rod (1) away from the liftgate.
38. Using Trim Stick C­4755 disengage the upper D­pillar
trim retaining clips (2).
39. Carefully disengage the upper D­pillar trim end tab (5)
from the rear header trim plate.
40. Disconnect the power liftgate D­Pillar switch and third
row power folding seat switch electrical connectors (3)
(if equipped).
41. Remove the upper D­pillar trim from the liftgate open­
ing.
42. Remove the six quarter trim retaining screws.
43. Pull quarter trim panel (5) from inner quarter panel (1)
enough to route the backup camera wiring harness
with the vehicle body harness.
Jun 30, 2011
All manuals and user guides at all-guides.com
9
K6861197