Safety Instructions - auna Blaster DAB Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions. All uses guidelines must be read before using the
device. Keep the instructions for future use.
• Read all the safety in for mation and instructions before using the
product. When passing this product to some one, include all documents.
• If you do not follow the operating instructions provided, it may
compromise the safety of your product and this may invalidate the
warranty.
• Do not expose the product to dripping or splashing .Do not place
objects filled with liquids,suchas vases ,on the product.
• If liquid or water spills onto the product ,switch it off immediately and
contact your dealer.
• If you are using a mains-powered adapter ,do not touch the product
with wet hands.
• The internal battery in this product is not user replaceable .Do not
expose the battery to excessive heat or naked flames. Ensure adequate
ventilation and airflow around the product , particularly when charging.
Dispose of the product in accordance with localenvironmentalrules.
• Using the product inrooms or climates withhighhumidity and
temperatures may cause condensation to form inside the product,
which candamage the product. Use the product in moderate climates
only.
• Do not use your product in extremely hot or cold temperature . Keep the
device away from heat sources , suchas radiators or gas/electric fires.
Do not expose your product to naked flames, suchas lighted candles.
• To charge your product ,only connect it to a supply source that meets
the safety
• Isolation requirements of EN 62368-1 or EN 60950-1 for an accessible
safety extra low voltage circuit. For this connection ,use either the
supplied Type-C cable or a suitably CE approved power adapter with
the correct USB output rating.
• Power the product using anexternal5 V DC 1 A power supply. The
maximum output current is 1 A, protected by an internal circuit.
• Before you charge your product ,ensure that the available supply
voltage corresponds with the required operation al voltage of the
product.
• Disconnect your product from the charging power supply if you will not
use your product for a long period of time (for example, if you are going
on holiday).
• Always unplug your product from the charging power supply before
cleaning. When cleaning the product ,do not use any type of abrasive
EN
21