Technical Specifications - GRAPHITE 58G044 Instrucciones De Uso

WARNING! When installing and adjusting the shoulder strap,
turn off the engine.
Correct fitting of the shoulder strap makes work much easier.
• Insert the shoulder strap snap hook into the holder on the device
housing.
• Use the clamp to adjust the length of the shoulder strap so that
the nozzle is in the most convenient position.
WORK / SETTINGS
ON / OFF
WARNING! Install batteries before commissioning. The device
requires the use of 2 batteries, otherwise it will not work. In
order for the device to work properly, the batteries should be
of the same capacity and similarly charged.
WARNING! Before inserting the batteries into the device,
always check that the switch operates correctly and returns to
the "OFF" position when released.
The blower has a switch lock button ( 4 ) for continuous operation
located on both sides of the handle ( 5 ).
Switching on - press the switch ( 6 ) ( fig. C ).
Switching off - release the pressure on the switch button ( 6 ).
Continuous work
Switching on - press the switch button ( 6 ) and then press the
switch lock button ( 4 ), release the pressure on the switch button
( 6 ) ( fig. D ).
Switching off - press and release the switch ( 6 ).
AIR STRENGTH ADJUSTMENT
The blower allows you to work with different blowing forces. The
blowing force is regulated by the degree of pressure on the switch
button ( 6 ) ( Fig. E ).
TURBO BUTTON
The turbo option is a momentary increase of engine revolutions and
blowing power during operation of the device.
The turbo button ( 3 ) only works for about 3 seconds, regardless of
how long the button is pressed.
To restart the turbo option, release the pressure of the turbo switch
button ( 3 ) and press it again ( fig. F ) .
BLOWER WORK
Hold the blower firmly by hand and perform the blowing operation.
Direct the air stream forward and slowly moving, blow the leaves
and trash in front of you.
When blowing around a building, large stone or vehicle, point the
nozzle away from them.
When performing corner operations, start at the corner and then
move to a wide area.
MAINTENANCE AND MAINTENANCE
WARNING! Before performing any installation, adjustment,
repair or maintenance operations, the batteries must be
removed from the device.
MAINTENANCE AND STORAGE
• After each use, wipe the outside of the blower with a cloth
moistened with soapy water.
• Do not use any cleaning agents or solvents as they may damage
the plastic parts .
• Make sure that no water gets into the device.
• Always keep the ventilation openings on the motor housing free.
• Only the maintenance procedures described in this manual may
be carried out at the device. All other activities may only be carried
out by an authorized service center.
• Do not make any changes to the design of the device.
• When not in use, the blower should be stored clean, on a flat
surface, in a dry place out of reach of children.
• All defects should be removed by the manufacturer's authorized
service department.

TECHNICAL SPECIFICATIONS

RATED DATA
58G044 battery blower
Parameter
Battery voltage
Engine speed
Air flow rate
Protection class
Weight (without batteries)
Year of production
58G044 means both type and designation of the machine
NOISE AND VIBRATION DATA
Sound pressure level
Sound power level
Acceleration value
Information on noise and vibration
The level of noise emitted by the device is described by: the sound
pressure level Lp and the sound power level Lw
A
measurement uncertainty). Vibration emitted by the device is
described by the value of vibration acceleration a
measurement uncertainty).
The level of emitted sound pressure Lp
level Lw and the value of vibration acceleration a
A
manual were measured in accordance with EN 60335-1: 2012; EN
50636. The given vibration level a
and to initially assess vibration exposure.
The given vibration level is representative only for the basic
applications of the device. If the device is used for other applications
or with other working tools, the vibration level may change. Higher
vibration levels will be affected by insufficient or too rare
maintenance of the device. The above-mentioned causes may
cause increased vibration exposure during the entire working
period.
To accurately estimate vibration exposure, consider the
periods when the device is turned off or when it is turned on
but is not used. After careful estimation of all factors, the total
vibration exposure may be much lower.
In order to protect the user against the effects of vibrations,
additional safety measures should be introduced, such as: cyclic
maintenance of the device and working tools, protection of the right
hand temperature and proper organization of work.
ENVIRONMENTAL PROTECTION
Electrical equipment must not be disposed off with
household waste and, instead, should be utilized at
appropriate facilities. Information on utilization can be
provided by the product vendor or the local
authorities. Waste electrical and electronic equipment
contains substances that are not neutral to the natural
environment.
constitutes a potential hazard to the environment and
to human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa
with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa Topex) informs,
that all copyrights to this instruction (hereinafter Instruction), including, but not
limited to, text, photographies, schemes, drawings and layout of the instruction,
belong to Grupa Topex exclusively and are protected by laws accordingly to
Copyright and Related Rights Act of 4 February 2004 (ustawa o prawie autorskim
i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the
entire Instruction or its parts without written permission of Grupa Topex are strictly
forbidden and may cause civil and legal liability.
9
Value
36 V DC (2x18V
DC)
20000 min
-1
150 km / h
III
2.5 kg
2020
L = 82.2 dB (A) K = 3dB
PA
(A)
L = 95,6 dB (A) K = 3dB
WA
(A)
a = 2.54 m / s K = 1.5 m /
2
h
s
2
(where K is the
A
(where K is the
h
, the sound power
A
given in this
h
can be used to compare devices
h
Equipment that is not recycled