Drilling Without Hammering - Hilti TE 60-AVR Manual De Instrucciones

All manuals and user guides at all-guides.com

5.2.2 Drilling without hammering

Note
Drilling without hammering action is possible when accessory tools with a special connection end are
used. Accessory tools of this kind are available from Hilti.
Alternatively, when the keyless quick-release chuck is fitted, smooth-shank drill bits for wood or steel,
for example, can be used to drill without hammering.
▶ Set the function selector switch to the "Drilling"
5.2.3 Mixing
Note
Use the mixing paddle only with the quick-release chuck.
Use the mixing paddle only when the reduced power (50%) setting is active.
1. Insert the quick-release chuck in the power tool's chuck.
2. Fit the mixing paddle into the quick-release chuck.
3. Set the function selector switch to the "Hammer drilling" position
4. Press the power reduction (50%) button.
◁ The product is ready for use.
5.3 Chisel positioning 8
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
Note
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
1. Set the function selector switch to the "Chisel positioning" position
2. Rotate the chisel to the desired position.
3. Turn the function selector switch until it engages in the "Chiseling"
◁ The product is ready for use.
5.3.1 Chiseling 9
▶ Set the function selector switch to the "Chiseling" position
5.3.2 Switch sustained operation on and off
Note
When chiseling, the control switch can be locked in the "on" position.
1. Push the lockbutton for continuous operation forward.
2. Press the control switch fully.
◁ The product then runs in sustained operating mode.
3. Push the lockbutton for continuous operation back.
◁ The product switches off.
20
position.
.
.
.
10
position.