POLTI MONDIAL VAP 6000 Instrucciones Para El Uso página 21

M.V.6000 M0S10367 1T03 BOZZA:Layout 1
• Attach the desired accessory to the han-
dle.
• Place the switch (8) in the CLOSED posi-
tion (8b).
• Make sure the connection is secure.
• To detach them, reverse the process.
VACUUMING
Whenever the water in the dirt container (L)
is very dirty, replace it as described in the
section on "Emptying and cleaning the dirt
container". When dirt in the dirt container (L)
reaches the maximum permitted level, vacu-
uming will be automatically shut down by the
safety float (P) (you will hear the motor run-
ning faster).
CAUTION: turn off the appliance and do not
start it up again until you have put water in
the container as described in the section on
"Emptying and cleaning the dirt container". If
you attempt to turn on the appliance before
this, you could damage the filter on the air
outlet (Q).
To resume cleaning, proceed as described in
the section on "Emptying and cleaning the
dirt container", and then add water to the
container.
EMPTYING AND CLEANING
THE DIRT CONTAINER
• Turn off the appliance with the main switch
(A) and unplug it.
• Release the two levers locking the dirt
container (K) in place and slide the con-
tainer (L) out of the appliance (fig.2).
• Open the lid on the dirt container using the
handle (fig.3).
• Clean the dirt container (L).
• If you want to continue working, fill the
container with water.
• Put the container back inside the appli-
ance, performing the procedure described
above in reverse order.
Note: empty the dirt container (L) before
putting away your Mondial Vap. One of the
biggest advantages of the Mondial Vap is
that it can be put away clean.
All manuals and user guides at all-guides.com
09/10/2013
MONDIAL VAP 6000
Mondial Vap has a convenient, accurate
pressure gauge (H) for displaying actual op-
erating pressure.
When the water tank is out of water, the out
of water light (F) will come on and an
acoustic signal will sound. Fill before contin-
uing to work as described in the section on
"Filling the water and detergent tanks".
When the detergent tank is empty, the deter-
gent indicator light (G) will flash and an
acoustic signal will sound.
Fill before continuing to work as described in
the section on "Filling the water and deter-
gent tanks".
The boiler may run out of water if the refilling
system is not working properly. This type of
fault is signalled by a flashing indicator light
(F) and an acoustic signal.
If the problem continues to occur, contact
the technical assistance service.
Wind up the cable on the pins (O) before
putting your Mondial Vap away (fig.5).
Mondial Vap accessories may be stored in
the convenient accessory rack (T). Hoses
may be hooked to the hose clips (R) (fig.5).
• Before treating leather, special fabrics and
21
9.13 Pagina 21
PRESSURE GAUGE
OUT OF WATER
OUT OF DETERGENT
BOILER OUT OF WATER
CABLE WINDER
ACCESSORY STORAGE
RECOMMENDATIONS FOR
USE OF ACCESSORIES
wood surfaces, consult the manufacturer's
instructions and always carry out a test on
a hidden part or on a sample of the mate-
rial. Allow the steamed part to dry to make
sure that no changes in colour or deforma-
tions have occurred.