Diamond Blade Installation; Water Tray Installation; Water Pump Installation - QEP Brutus 60010 Manual De Operación

BLADE INSTALLATION (cont.)
Blade
Shaft
Lock
Fig H5
With one hand, press the Blade Shaft Lock. With the
other, tighten the blade shaft nut (Fig H5). Release the
Blade Shaft Lock after the nut is tightened (Fig H6).
DO NOT OVERTIGHTEN.
Fig H7
Loosen the Adjustment Knob and lower the Blade Guard,
and tighten. (Fig H7). Then, slightly loosen the Rear
Support Adjustment Knob and lower the cutting head so
the blade is approx. 1/4" below the cutting surface, tighten
firmly to hold cutting head in place (Fig H8).
CAUTION:
READ "CUTTING OPERATION"
COMPLETELY ON PAGE 12,
BEFORE USING SAW

WATER TRAY INSTALLATION

Fig J1
Slide the water tray into position on the tile saw frame ( F i g .
J1). Ensure drain plug is firmly in the drain hole before
filling the water tray (Fig J2). Fill the water tray
approximately 2/3 full - to edge of ledge.
CAUTION: Do not add chemicals or detergents to the
water
Fig H6
Fig H8
Water
Fill Line
Fig J2
- 11 -

WATER PUMP INSTALLATION

Fig K1
Remove the water pump from its box and ensure that it is
not cracked or damaged in any way (Fig K1). Insert one end
of the clear plastic tubing to the fitting at the base of the
Blade Guard (Fig K2).
Fig K3
Attach the other end over the nipple on the water pump
(Fig. K3). Place the pump in the rear of the water tray with
the tube projected from the side (Fig K4). Be sure the water
level is high enough to cover the water intake filter. Keep all
debris and sediment clear of water intake filter.
Fig K5
Keep the power cord out of the water and plug it into the 3-
prong receptacle next to the power/reset housing on the
front top of the saw (Fig K5). The water flow rate can be
adjusted by rotating the Flow Adjuster located on the water
pump (Fig K6). Rotate counterclockwise to increase water
flow, and clockwise to decrease flow.
CAUTION:
READ "WATER PUMP SAFETY"
AND "WATER PUMP OPERATION &
MAINTENANCE" ON PAGE 11 COMPLETELY,
BEFORE USING SAW
Fig K2
Fig K4
Decrease
Increase
Flow
Flow
Fig K6