Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Ofrecido por www.electromanuales.com
5.
PC Input
is for connecting a personal computer to the TV set.
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC.
Note: You can use YPbPr to VGA cable(not supplied) to enable YPbPr signal via PC input.
WARNING: You cannot use PC and YPbPr at the same time.
6.
S/PDIF Coaxial Out
outputs digital audio signals of the currently watched source.
Use an SPDIF coaxial cable to trasfer audio signals to a device that has S/PDIF input
Viewing the Connections - Side Connectors
1.
CI Slot is used for inserting a CI card. A CI card allows you to view all the
channels that you subscribe to. For more information, see "Conditional
Access" section.
2.
Side USB input.
Note that programme recording feature is available via this USB input. You
can connect external hard disk drives to this input.
3.
Video Input is used for connecting video signals of external devices.Connect the video
cable between the VIDEO IN socket on the TV and the VIDEO OUT jack on your device.
4.
Audio Inputs are used for connecting audio signals of external devices. Connect
the audio cable between the AUDIO INPUTS on the TV and the AUDIO
OUTPUT jacks on your device.
Note: If you connect a device to the TV via the VIDEO INPUT, you should
also connect your device with an audio cable to the AUDIO INPUTS of the TV
to enable audio.
5.
Headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones
(optional).
Power Connection
IMPORTANT: The TV set is designed to operate on 220-240V AC, 50Hz.
•
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.
Aerial Connection
•
Connect the aerial ,cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
English - 48 -
Publicidad
Tabla de contenido
