Connecting To A Dvd Player; Remote Control Handset; Inserting Batteries; Switching On/Off - Nevir 7201-40HD-N Manual De Instrucciones

Ofrecido por www.electromanuales.com

Connecting to a DVD Player

If you want to connect a DVD player to your TV, you
can use the connectors of the TV set. DVD players
may have different connectors. Please refer to your
DVD player's instruction book for additional information.
Power off both the TV and the device before making
any connections.
Note: Cables shown in the illustration are not
supplied.
•
If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to a DVD player
as illustrated below, switch to the HDMI source. See
"Input Selection" section.
•
Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
•
You may also connect through the SCART sockets.
Use a SCART cable as shown below.
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

•
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
•
Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

•
Connect the power cord to the 220-240V AC, 50
Hz. Then the standby LED lights up. (The led will
blink during the standby On/Off)
•
To switch on the TV from standby mode either:
•
Press the " " button, P+ / P- or a numeric button
on the remote control.
•
Press the " " button, -P/CH or P/CH+ button on
the TV. The TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

•
Press the " " button on the remote control or press
the " " switch on the TV, so the TV will switch to
standby mode.
•
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 51 -