Prepare The Remote Control; Set Up A Wi-Fi Network For Airplay - Philips DS9800W Manual Del Usuario

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
For first-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before pressing any function button on the remote
control, first select the correct source with the
remote control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
All manuals and user guides at all-guides.com
4 Set up a Wi-
Fi network for
AirPlay
Note
•
Some operations may vary as you use different types
of wireless routers.
•
You are recommended to change the SSID of your
wireless router to 'PhilipsFidelioAP'. In this way, the
SoundSphere speakers can get connected to the
router automatically after power-on. You can hear
a beep after successful connection. Then, proceed
to 'Connect an AirPlay device to the same Wi-Fi
network' directly.
The SoundSphere speaker system is
compatible with the following iPod/iPhone/
iPad models:
• iPad 2
• iPad
• iPhone 4
• iPhone 3GS
• iPod touch (2nd, 3rd, and 4th generation)
Before setup of the Wi-Fi network, check
the points below.
EN 11