Advanced control
For advanced control, you can use your
AirPlay device to download the Philips Fidelio
application from Apple Application Store.
Update firmware
Note
•
You can only update the firmware from a PC/Mac.
If the SoundSphere speaker system is not
connected to any wireless router, follow the
procedures below.
1
Power on the SoundSphere speakers (see
'Prepare - Connect - Connect power
- Connect power to speakers').
»
It takes about 35 seconds for the
speakers to boot up. During boot-up,
the LED indicator on the back of the
main speaker blinks in green quickly.
»
After boot-up, the LED indicator
starts to blink in green slowly.
2
Press and hold WiFi SETUP on the back of
the main speaker for more than 5 seconds.
»
The LED indicator blinks in green and
yellow alternately.
3
Enter the list of available wireless
networks on your PC/Mac.
4
Select Philips_Fidelio_AirPlay (or the
user customized name) from the list of
available networks.
5
After successful connection, open the
web browser on your PC or Mac, then
type in 169.254.1.1 at the address bar.
•
Or open
Safari and then select
'Philips_Fidelio XXX' from the
bonjour pull-down list.
•
The DS9800W configuration page is
displayed.
All manuals and user guides at all-guides.com
6
Select the Firmware Update tab, then
click OK on the page.
»
A new page is displayed.
7
Click click here on the page, then
click Browse on the next page that is
displayed.
»
A dialog box with update files is
displayed on the left of the window.
8
Click the .bcd update file, then click
Open.
9
Click Upload on the next page that
is displayed, then click Ok on the
confirmation page.
»
A progress bar is displayed.
10
Wait until successful update, then click
Ok to confirm.
Tip
•
If your SoundSphere speakers and PC/Mac have
already been connected to the same router, proceed
with steps 5 to 10 in the above to upgrade the
firmware.
•
In case of update failure, use an Ethernet cable to
connect your PC/MAC to the same router as the
SoundSphere speakers, and then proceed with steps
5 to 10.
Charge your iPod/iPhone/iPad
with the standalone dock
You can charge your iPod/iPhone/iPad through
the supplied standalone docking charger.
Compatible iPod/iPhone/iPad
The docking charger supports the following
iPod, iPhone and iPad models.
Made for
•
iPad 2
•
iPad
•
iPhone 4
•
iPhone 3GS
•
iPhone 3G
EN
19