1
Make sure that the wireless router is
powered on and working properly.
2
Make sure that the LED indicator on the
back of the main speaker blinks in green
slowly.
3
Check the type of the wireless router you
use.
Connect speakers to a Wi-Fi
network (router)
Select a scenario below that matches your
router type.
Note
•
Each time when the speakers are powered on again,
the speakers enter the latest configured Wi-Fi
network automatically.
•
In case of setup failure, repeat the steps, or press and
hold
on the back of the main speaker and try again.
Scenario 1: Connect to a WPS-PBC
router
1
Press WiFi SETUP on the back of the
main speaker.
»
The LED indicator blinks in red, green
and yellow alternately.
12
EN
All manuals and user guides at all-guides.com
WIFI
SETUP
2
Press the WPS button on the wireless
router.
»
After a while, the LED indicator stops
blinking and stays green, and the main
speaker beeps.
»
The speakers join the Wi-Fi network
successfully.
WPS
Tip
•
To change the name of the SoundSphere speakers
for AirPlay, proceed with steps 2 to 7 in 'Scenario 2:
Connect to a non-WPS router' below.
•
For some wireless routers, you may need to hold
the WPS button for WPS connection. See the user
manuals of the specific routers for details.
Scenario 2: Connect to a non-WPS
router
You can connect the speakers to a non-WPS
router through
•
an iOS 4.2 (or later) enabled iPod
touch/iPhone/iPad
•
a Wi-Fi enabled PC or Mac installed
with iTunes 10
1
Press and hold WiFi SETUP on the back
of the main speaker for more than 5
seconds.
»
The LED indicator blinks in green and
yellow alternately.