prior to Fitting the custom install series speakers
CAUTION: These Custom Install loudspeakers can only be fixed into plasterboard (dry-lined) or suspended
ceilings/ walls with a thickness of up to 45mm (1
work constructed to provide a structure for the Tri Grip
of your ability to provide a secure and safe fixing, do not attempt to fix these speakers, please obtain the services
of a competent and qualified trades person.
CAUTION: Ensure that there are no water pipes or electricity cables running within the wall structure before cutting
the speaker apertures. Work from secure steps and avoid trailing wires.
over tightening Warning
ATTENTION INsTAllErs:
Do not over-tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on any in ceiling/ in wall speaker
can result in damage to the speaker mounting hardware, ceiling/ wall or speaker frame, and/ or deflection in the speaker
frame during installation.
If you notice any of the above during installation, you have overtightened the Tri Grip dog leg. Back off the mounting screw
until deflection is reduced to allow the product to sit firmly against the ceiling / wall.
Do not exceed 5Kgf/cm (4.34 lbf/inch.) or 0.5 NM when tightening the Tri Grip dog leg screws.
When are using a cordless screwdriver/ drill to install this product ensure the clutch is set to it's lowest setting to avoid from
over-tightening and damaging the mounting hardware.
CI Trimless Manual ~ Full ~ Multi Lang.indd 3
All manuals and user guides at all-guides.com
"). Solid wall installation will require channeling out and frame
3/4
dog legs to clamp to. For safety reasons, if you are unsure
®
29/05/2012 15:07:03