Bestway Hydro Force 58202 Manual Del Propietário página 4

1. Set up and fill the pool with water to the required level according to the pool's owner's manual.
2. Connect the hose from the Filter Pump's inlet port to the Pool's outlet valve:
a) Place the loose Hose Clamps on both ends of a Filter Pump Hose.
b) Attach the hose to Filter Pump's inlet port and the Pool's outlet valve.
c) Tighten the Hose Clamps.
3. Connect the hose from the Filter Pump to the Ozone generator:
a) Place the loose Hose Clamps on both ends of the Ozone generator Hose.
b) Screw one Adapter to the Ozone generator's inlet valve and make sure the washer is in place.
c) Attach the hose to the Filter Pump's Outlet port and the Ozone generator's adapter.
d) Tighten the Hose Clamps.
4. Connect the hose from the Ozone generator to the Pool:
a) Place the loose Hose Clamp on both ends of a Filter Pump Hose.
b) Attach the hose to the Pool's inlet valve and tighten the Hose Clamp.
c) Screw the other Adapter to the Ozone generator's outlet port and attach the other end of the hose to the Adapter and tighten the Hose Clamp.
5. Loosen the Hose Clamps on the Pool's Inlet and Outlet Valves; replace the Stopper Plugs with Debris Screens. Water now flows to the Filter
Pump and the Ozone generator. With the Hoses and the Debris Screens in position, tighten the Hose Clamps.
6. Check that every port and valve is connected correctly.
II. Installation for 800gallon Sand Filter. (See Fig. 2)
Fig. 2
>1/2 inches
Debris Screens
(F4030)
Illustration (not to scale) of Pool and Sand Filter and the Ozone Generator.
1. Set up and fill the pool with water to the required level according to the pool's owner's manual.
2. Refer to the Sand Filter's manual to connect the Sand Filter to the Pool Be sure to backwash and rinse the sandbed as outlined.
3. Connect the Sand Filter to Ozone generator:
NOTE: Ensure the Control valve is set to Closed function.
a) Place the loose Hose Clamps on both ends of the Ozone generator Hose.
b) Screw the Adapters to the Ozone generator's inlet port and Sand Filter's Port A.
c) Attach the hose to the Adapters and tighten the Hose Clamps.
4. Attach the Ozone generator to the Pool:
a) Place the loose Hose Clamp on one end of the Hose.
b) Attach the hose to the Pool's Inlet Valve and tighten the Hose Clamp.
c) Attach the hose to the Ozone generator's outlet port; Screw the threaded locking ring into position.
5. Loosen the Hose Clamps on the Pool's Inlet and Outlet Valves; replace the Stopper Plugs with Debris Screens. Water now flows to the Sand
Filter and the Ozone generator. With the Hoses and the Debris Screens in position, tighten the Hose Clamps.
6. Check that every port and valve is connected correctly.
All manuals and user guides at all-guides.com
Inlet Valve
P6124
A
Clear Water System
P6124
B
Outlet
Valve
Water flow
Inlet
P6321
P6005
P6124
P6230
4
P6321
P6005
P6124
P6230
Sand Filter
Bestway
®
S-S-000860