General Operation - Eaton Indu Tel Instrucciones De Servicio

Adjust ringing volume ............................................................................... 12
Adjust the ringing melody ......................................................................... 12
Set dialling mode ..................................................................................... 13
Restore to as-delivered condition ............................................................. 13
Signalling tones during programming .................................................. 13
General information
Service ............................................................................................................. 14
Care and maintenance.................................................................................... 14
Warnings and security information ............................................................... 14
Technical Specifications
EC Declaration of Conformity
EMC-Directive
...................................................................................................... 16

General operation

1. The InduTel can be operated in the analogue, public telephone network and
connected to analogue terminals of branch exchanges.
2. The telephone has a receiver accommodation with a magnetic contact as hook
switch. To disconnect an existing connection, the receiver must be replaced. For
disconnecting an existing connection, all you need to do is press the disconnect key
on the keypad.
3. When programming the settings, the receiver must be off the hook. You enter
programming mode by simultaneously pressing the asterisk and the pound sign key.
4. If a procedure has been completed successfully, you will hear an acknowledgement
signal. An error tone informs you of any operating mistakes.
5. Should more than 2 minutes pass before you start dialling, the exchange may cut off
the power supply. The dial tone can no longer be heard. In this case you should put
the receiver back on the hook and wait approximately 2 seconds before you lift it
again. Programming sessions that have been started, but have not been completed,
must be repeated.
6. When you receive a call, the InduTel rings with the volume and melody you have
selected.
7. Entering your personal identification number (PIN) you may partly or completely
restrict functions and settings. Forgetting your PIN can be compared to losing a key. If
you have forgotten your PIN, please contact our technical support service.
.......................................................................................... 14
................................................................................. 15
........................................................................ 16
3