Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
As-delivered condition
Telephone presetting
Dialling procedure
Signalling key function (R key)
AKZ automatic pause
Pause following AKZ
Last number redial memory
Restrictions
Amplified listening in receiver
PIN
Ringing melody
Ringing volume
Receiver volume
Using the programming options, you may reset this as-delivered condition at any time. The
PIN will not be altered by resetting.
Mounting and installation
Wall mounting
Mount the brackets on the telephone with two screws each. To do this, use the provided
countersunk screws M5 x 8 mm. Fasten the telephone on the wall using four screws (up to
max. size Ø 8 mm). Remove the keypad plate and the handset, pull the telephone line
through the cable gland and connect it with terminal TCP/La – TCP/Lb (TCP: Terminal
Connection Point).
Use cables with a sheath diameter of 5 to 9 mm only, otherwise the IP 66 degree of
protection can not be guaranteed.
Plug the ribbon cable onto the pin contact strip of the keypad plate.
Tighten the keypad plate using four screws.
4
Dual-tone multifrequency (DTMF),
signal duration 90 ms
Flash 120 ms
none
3 seconds
Empty
Programming restricted
Two levels (6 dB / 12 dB)
0000
7
6 = max
1 = min, default value
Publicidad
Tabla de contenido
