BaByliss PRO LO-PRO FX825E Manual De Instrucciones página 7

ENGLISH
Please carefully read the safety
instructions before using the
appliance.
LO-PRO CLIPPER
FX825E
adaptateur
Vibrations
LpA (dB(A))
OPERATING INSTRUCTIONS
1. Before using the clipper for the
rst time, charge continuously for
3 hours. Maximum battery capa-
city will only be reached after 3
charging and discharging cycles.
2. Make sure the switch on the clip-
per is in the «0» (OFF) position.
Connect the charging jack into
the receptacle on the bottom of
the clipper. Plug the adapter into
electrical outlet. The charging
indicator will light up blue and
blink to indicate that the char-
ging has begun. Charging is com-
plete after 3 hours.
3. The adapter may become warm
while charging. This is normal.
4. Preserving the battery: in order
to maintain the optimum capa-
city of the rechargeable battery,
the clipper should be recharged
for 3 hours approximately every
6 months.
5. Make sure the switch is in the OFF
position when the clipper is not
operating.
CA78M
< 2,5 m/s²
< 70
6. If the charging light starts to ash
rapidly (more than 4 ashes per
second), the appliance is faulty.
If this happens, stop charging
and remove the adapter from the
outlet and contact an authorized
service center.
FOR DIRECT PLUG-IN
OPERATION
Make sure clipper is o . Connect
charging jack into the receptacle
at the end of clipper and plug the
adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to
ON (marked «I»). To stop operation,
set to the OFF (marked «0») posi-
tion.
VERY IMPORTANT:
MUST BE CLEANED AND OILED
ON A REGULAR BASIS FOR PRO
PER FUNCTIONING. FAILURE
TO REGULARLY CLEAN AND OIL
THE BLADES WILL VOID THE
WARRANTY.
USER MAINTENANCE
INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades be-
fore and after use. This will ensure
maximum cutting performance
and proper maintenance. Hold the
clipper away from your body in a
downward position and apply a
drop of BaBylissPRO lubricating oil
on the front and sides of the cutter
blade. Wipe o excess oil with a
soft, dry cloth.
Do not pull, twist, or wrap the
7
BLADES