DWT K13-15 OA-AL Manual Original página 13

Symbol
I
designation
The compressor is designed to provide various pneu-
matic tools, devices and appliances with compressed
air�
These compressor models do not require lubrication, it
makes easier their using, and the received compressed
air does not contain oil impurities�
Using the compressor allows you to save electrical
power, mechanize work, and increase the speed of
work performance�
Various pneumatic tools significantly expand the scope
of the compressor application�
components
1 Cylinder cover
2 Air filter cover
3 Engine
4 Ventilation slots
5 Protection unit
6 Button of protection unit
7 Transportation handle
8 Receiver manometer
9 Pressure relay (pressostat)
10 On / off switch
11 Piping
12 Outlet fitting
13 Check valve
14 Safety valve
15 Unloading valve
16 Rubber mount *
17 Drain valve
18 Receiver
19 Wheel *
20 Nut for installing rubber mount *
21 Washer for installing rubber mount *
Meaning
Protection class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
Appliance
Appliance
22 Bolt for installing rubber mount *
23 Wheel installing stud *
24 Wheel installing nut *
25 Hose *
26 Hose clamp *
27 Fitting *
28 Quick-change fitting*
29 Quick-change adapter *
30 Screw of cylinder cover
31 Screw of air filter cover
32 Filter element *
33 Check valve housing
34 Piston
35 Spring
36 Rubber ring
37 Screw plug
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of
Before any procedures, be sure to switch off the
appliance, remove the current-carrying cable from
the socket and discharge pressure in receiver 18
(open the valve(s) on outlet fitting(s) 12).
Do not draw up the fastening elements
too
thread.
Mounting / dismounting / setting-up of
some elements is the same for all appli-
ance models, in this case specific mod-
els are not indicated in the illustration.
For improve understanding of drawings,
some structural elements of appliances
are not shown onto drawing.
Rubber mounts assembly / disassembly (see fig. 1)
• Install the rubber mounts 16 as shown in fig. 1.
• Disassemble in the reverse sequence�
Wheels assembly / disassembly (see fig. 2)
[K13-30 OA-AL, K13-30 OA-CU, K26-50 OA-AL,
K26-50 OA-CU]
• Install wheels 19 as shown in fig. 2.
• Disassemble in the reverse sequence�
Connecting / disconnecting the air hose
Using thread fittings (see fig. 3)
• Attach hose clamp 26 to the end of hose 25 (see
fig. 3.1).
• Install fitting 27�
• Tighten the screw of hose clamp 26�
• When connecting, screw fitting 27 on outlet fitting 12
(see fig. 3.2).
• When disconnecting unscrew fitting 27�
English
13
appliance elements
tight to avoid damaging the