Orima ORCD 350 2P Manual De Instrucciones página 28

cloth or vacuum cleaner may be used for cleaning. 

DO NOT use detergents containing abrasive particles, acid,
alcohol or benzene for cleaning the appliance inner and outer
surfaces.

DO NOT use for cleaning cloths or sponges that have coarse
surfaces intended for scrubbing.

IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD,
LEAVE ITS DOORS OPEN.
ATTENTION! Outer of the doors – glass – clean with agents intended for glass

cleaning.
Remarks on the appliance operating noise. As the appliance operates and
goes through the freezing cycle, various noises will be emitted. This is normal
and is not a sign of any malfunction.

As the refrigerant circulates around the refrigeration system, it causes sounds like
murmuring, bubbling, or rustling.

Louder sounds like popping or clicking may be heard for a short time as the
refrigerator compressor switches on.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a helper.
You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors YOU CAN NOT lay the refrigerator horizontally!
Do the actions below in the order they are listed:
For models CD350 (see page ):
WARNING! Turn off the appliance and pull
the plug out of the electricity supply socket.
1. Unscrew two screws 7 and remove the
bottom bracket 8 together with the set of
washers 6 on the axle and the spacer 5.
2. Unscrew two screws 7 and remove the
bracket 11. Remove the door 4.
3. Unscrew the axle 2 together with the nut 1
and washers 3 from the upper bracket and
screw all this set on the reverse side of the
door;
4. Before hanging the door, turn the door over
0
by 180 and insert the upper axle in the
door.
5. Unscrew fixing screws 12 from doors,
remove handles 13 and fix them screwing in
free holes on the same side. Plate 10
remains in its place.
6. Before screwing the bottom bracket 8
together with the set of washers and
spacers on the reverse side of a cabinet,
insert the bracket axle to the door.
7. Screw the bracket 11 on the reverse side of
a cabinet.
26