Alto Professional TS408 Guia Del Usuario página 57

NOTICE CONCERNING FCC REGULATIONS: You are cautioned that changes or modifications not expressly
approved by the part responsible for compliance could void the user's authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures: (a) reorient or relocate the receiving
antenna; (b) move this unit; (c) increase the separation between the equipment and receiver; (d) connect the equipment
into an outlet on a circuit different from that to which the receiver is connected; (e) be sure that all cables are properly
shielded, using a choke or ferrite where appropriate; or (f) consult the dealer or an experienced radio/television
technician for help. This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and your body.
RF Warning Statement: The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction. Avoid using this device in a high RF-radiated environment.
For Canadian models: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development (ISED) Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device. Under ISED regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by ISED. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication. This radio transmitter (identify the device by certification number, or
model number if Category II) has been approved by ISED to operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. This unit
does not exceed the Class B limits for radio noise emission from digital apparatus set out in the radio interference
regulations of the Canadian Department of Communications. This device operates on a no-protection, no-interference basis.
Should the user seek to obtain protection from other radio services operating in the same TV bands, a radio licence is
required. For further details, consult Innovation, Science and Economic Development Canada's document Client Procedures
Circular CPC-2-1-28, Voluntary Licensing of Licence-Exempt Low-Power Radio Apparatus in the TV Bands.
Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with greater than 20 cm between the radiator & your body.
For wireless products supporting the 5G frequency band (if applicable): Usage of the 5.15–5.25 GHz band are
restricted to indoor operation only. This applies to the following countries: AT, BE, BG, CZ, DK, EE, FR, DE, IS, IE, IT,
EL, ES, CY, LV, LI, LT, LU, HU, MT, NL, NO, PL, PT, RO, SI, SK, TR, FI, SE, CH, UK, HR.
For 240-volt use in U.K., use NEMA
ESD/EFT Warning: This unit may contain a microcomputer for signal processing and control functions. In
very rare situations, severe interference, noise from an external source, or static electricity may cause it to
lock up. In the unlikely event that this should happen, turn off the unit, wait at least five seconds, and then
turn it back on again. The pins of connectors identified with this ESD warning symbol should not be
touched.
®
-style 240-volt plug. For other countries use proper plug for local outlet.
9