Example A: One Loudspeaker; Example B: Two Loudspeakers - Alto Professional TS408 Guia Del Usuario

Setup
Examples
Items not listed under Introduction > Box Contents are sold separately.
Note: These examples show the rear panel used by the TS410, TS412, and TS415 models, though all four
models in the TS4 Series have the same input and output.
Guitar

Example A: One Loudspeaker

Microphone
Connect a dynamic microphone to the Input 1 using an XLR or
1/4" (6.35 mm) TRS cable. Connect a guitar with an active
pickup to the Input 2 using a 1/4" (6.35 mm) TS or TRS cable
(see your guitar's documentation for cable requirements).
Note: When using the TS4 Series loudspeaker with a guitar, we
recommend using one with active pickups rather than passive
pickups. If you use a guitar with passive pickups, connect it to
an external preamp or direct input (DI) box, and connect the
line-level output to the loudspeaker.
Also, use dynamic microphones with the TS4 Series loudspeaker
rather than condenser microphones. If you use a microphone that
requires +48V of phantom power, connect it to an external
phantom power supply before connecting it to the loudspeaker.
Power Outlet
Tablet

Example B: Two Loudspeakers

Connect the left and right output of your DJ mixer, controller, etc. to Input 1 on the two loudspeakers using
XLR or 1/4" (6.35 mm) TRS cables.
DJ mixer
Power Outlet