Cleaning Filters; Replacement Filters - Shark STRATOS HZ3000 Serie Guia Del Usuario

MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.

CLEANING FILTERS

Regularly rinse and replace the filters to maintain your vacuum's suction power and to maximize the
effectiveness of odor neutralizer technology.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
PRE-MOTOR FILTERS
The Pre-Motor Filters should be rinsed
every month. To remove the pre-motor
filters, detach the dust cup, then slide down
the Filter Access buttons on both sides of
the dust cup lid. Pull out the filter housing,
then lift out the Felt Filter by the pull tab.
Next, remove the Foam Filter. After the
filters have been rinsed and are completely
dry, insert the foam filter into the housing
first, then slide in the felt filter, and reinstall
the housing into the dust cup lid.
HEPA FILTER
The HEPA Filter should be rinsed every 6
months. To remove the HEPA filter, detach
the dust cup, then pull the Filter Release
tab on the handheld vacuum filter cover.
Remove the cover, then squeeze the side
tabs on the HEPA filter and lift it out. After
the filter has been rinsed and is completely
dry, reinsert it into the handheld vacuum,
then reattach the filter cover.
s h a r kc l e a n . c o m

REPLACEMENT FILTERS

Replacement Pre-Motor Filter Kit
XFFKHZ3000
Replacement HEPA Filter
XHFHZ3000
NOTE: The pre-motor filters should be replaced every
2.5 years. The post-motor filter should be replaced every
3 years.
MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
Remove the handheld vacuum from the
wand and check all dust cup intake openings
for debris or blockages.
CHECK FLOOR NOZZLE
Detach the wand, then tilt the floor nozzle
Debris Intake back and check openings for
blockages.
CHECK WAND
Detach the wand and check it for blockages.
s h a r kc l e a n . c o m