Tabla de contenido
Publicidad
T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
valves
spout
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ Inspect the faucet for shipping damage before instal-
lation. Hansgrohe will not honor claims for shipping
damage after the faucet is installed.
⁄ This faucet does not include a drain or a pull rod.
⁄ The check valves should be inspected yearly, and
replaced if dirty or worn (see page 23).
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1³⁄₁₆"(30 mm)
1³⁄₁₆"-1⁵⁄₁₆" (30 mm - 34 mm)
1³⁄₁₆"(30 mm)
E N G L I S H
⁄ The included adapters must be used. They adapt the
G ⅜ supply hoses to ⅜" stops.
⁄ The adapters include sediment filters. If the flow from
the faucet diminishes over time, clean the filters (see
page 23). Do not permanently remove the filters
as debris from the water line will damage the faucet
cartridge.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a
safe place. The receipt is required should it be neces-
sary to request warranty parts.
Publicidad
Tabla de contenido
