Tabla de contenido
Publicidad
T EC H N I C A L IN F O RMATION
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
valves
spout
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
INSTALL ATI O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
⁄ Inspect this faucet thoroughly before installation.
Claims for shipping damage made after installation
will not be honored.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
This faucet requires ½" hot and cold supply
lines (not included).
⁄ The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada. The
drain is intended for use in a sink with an overflow.
If your sink does not have an overflow, or if this
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (5.4 L/min)
1¼" (32 mm)
1⅜" (36 mm)
1⅝" (40 mm)
E N G L I S H
drain is too small for the hole in your sink, please
refer to the instructions included with the sink. Some
sinks include special drain installation instructions
and/or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost of a
specialty drain.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
Tabla de contenido
