Publicidad
Video Instruction: bit.ly/nlrbuild
support@nextlevelracing.com
PARTS
2 X M6 15MM BOLT
4 X M6 WASHER
2 X M6 FLANGE NUT
WARNING
Do not use power tools for assembly as over tightening can damage your frame.
Do not adjust the hubs while user is sitting in cockpit. Make sure user is out of the cockpit before adjusting
Make sure the hubs are tightened fully before using the cockpit (spin the hub clockwise to ensure it is fully tight)
Make sure strap on wheel bar is tight when adjusting the hubs otherwise the wheel will fall when hubs are open.
05 Align rudder plate with the holes on the TPR rudders then secure
ASSISTANCE
ASSEMBLY
VIDEO
bit.ly/nlrbuild
If you require further support with your product please
contact our friendly team at: support@nextlevelracing.com
16
17
Publicidad
