Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
CAUTION: HOT! DO NOT OVER INFLATE. DO NOT HOLD IN HAND WHILE OPERATING
• PLACE INFLATOR ON A HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in
"accessory" or "on" position. Please make sure emergency brake is set and car
is in park.
2. Always ensure air hose chuck touches the core of the valve stem for proper
inflation.
3. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
4. Always use a pressure gauge to check tyre pressure. DO NOT overinflate.
5. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure
markings. Be careful not to inflate items beyond their capacity.
6. While operating, never block the inflator input or output.
7. Keep inflator out of reach of children.
8. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
TECH SPECS
TYRE INFLATION TIME
CFM
DIGITAL GAUGE
POWER SOURCE
REPLACEABLE FUSE
POWER CORD LENGTH
AIR HOSE LENGTH
TOTAL REACH
LED LIGHT
* (0-35 PSI, Standard Tyre: P195/65 R15)
4 min*
1.0 @ 0 PSI (28.3 LPM)
0-99 PSI
12 volt accessory power outlet
5mm x 20mm 250V 15A
10.2ft. (3.1m)
1.67 ft. (51cm)
12.0 ft. (3.65m)
355 lumens @300mm

Publicidad

Tabla de contenido
loading

Tabla de contenido