Other Functions - Klarstein ICEWIND PLUS SMART Manual Del Usuario

OTHER FUNCTIONS

Memory function
• When the unit is switched on again after an interruption of the power supply
or a power failure, a beep sounds 10 times (once per second), with no screen
display and no action performed. After 30 seconds, the unit returns to the
function that was set before it was switched off (all functions, except sleep
mode, are restored when it is switched on again, including the new function
for protection against unintentional long-term operation).
If you press the On/Off button within the recovery time, the last set function is
•
restored immediately.
• The countdown of the timer function is also saved. The maximum deviation
after a power failure is 5 minutes (the time during which the unit was switched
off by the power failure is not included).
If the unit has been switched off normally and you switch it on again after the
•
power supply has been interrupted, the memory function is not activated and
the unit is in normal operating mode.
Water shortage protection function
• When the cooling function of the unit is activated, it starts with a 45-second
delay because the unit first checks whether there is enough water in the water
tank and it takes another 5 seconds to determine the operating status of the
cooling.
• When the cooling function has been activated, the water pump pumps water.
Regardless of whether there is water in the water tank, the magnetic switch
connected to the MCU connection is not detected for the first 50 seconds
after the water pump is switched on. The state of the magnetic switch is
determined between the 45th and 50th second. Depending on the state of
the magnetic switch, it is determined whether the water pump continues
operation or stops operation.
• After 45 seconds, if the water level in the water tank is found to be too low for
5 consecutive seconds, the water pump stops operating. The unit beeps for 10
seconds and the humidification indicator light goes off.
WiFi function
• In operating mode, press and hold the wind mode button
After a beep sounds, the WiFi indicator light flashes rapidly for approx.
5 seconds and app networking can be configured in standard mode. If no
connection is established within 3 minutes, the WiFi indicator goes off. To
reconnect, press and hold the wind mode button for 5 seconds. After a beep
sounds, the WiFi module is reset, the WiFi indicator light flashes quickly for
about 5 seconds and the app networking can be configured in standard mode.
When the WiFi indicator light is flashing rapidly, press and hold the wind mode
button again for 5 seconds. After a beep sounds, the WiFi indicator flashes
slowly and the app networking can be adjusted in compatibility mode.
for 5 seconds.
EN
23