Working With The Device; Adjusting The Seat - Gymrex GR-MG120 Manual De Instrucciones

a) Attach the pedals (21, 24) to the device cranks (22, 23). Each pedal is marked
with an "L" - for left and an "R" - for right. Mount the left pedal by turning it
counter clockwise. Mount the right pedal by turning it clockwise. Make sure
the pedals are installed on the correct sides.
CAUTION! The pedal nut must be properly tightened in the crank hole,
otherwise the thread could be flattened!
CAUTION! Before mounting the pedals, the threads can be oiled. It will help
to replace them later.
CAUTION! Install the pedals securely enough! After one week of use,
tighten the pedals again! Regularly check the stability of the pedal mounting!
All connections of the device should be properly fastened and tightened. After carrying
out the given assembly steps, you may start working with the device.

3.3. Working with the device

3.3.1.

ADJUSTING THE SEAT

a) VERTICAL
Loosen the seat adjustment knob and remove it. Adjust the seat bracket to the
desired height by aligning the holes. Lock the position by inserting the knob,
tighten.
b) HORIZONTAL
Loosen the locking knob and remove it. Adjust the seat position to the desired
position by moving it towards the handlebar or in the opposite direction. Align
the adjustment holes. Lock by inserting the knob, tighten.