Gymrex GR-MG120 Manual De Instrucciones página 29

Remove used batteries from the device following the same procedure as for their
installation.
Hand the batteries over to the institution responsible for their disposal.
DISPOSAL OF USED DEVICES.
At the end of its service life, this product must not be disposed of with normal
household waste but must be taken to a collection point for recycling of electrical
and electronic equipment. This is indicated by the symbol placed on the product,
operating instructions or packaging. The materials used in this device are
recyclable according to their labelling. You make an important contribution to
protecting our environment by reusing, recycling or otherwise disposing of used
equipment.
Please contact your local authority for the appropriate disposal point.
TROUBLESHOOTING
The problem
The display of the
device is not working
The device display
does not calculate
training values
The device is unstable
The device
rattles/squeaks
Possible cause
1. Discharged
2. Sensor cable is not
connected to the LCD panel
1. Damaged sensor cable or
LCD panel
1. The device bases are not
level
1. Unstable
2. No oiling of the mounts
Work
batteries 1. Replace the batteries with
new ones
2. Connect the sensor cable
1. Check the sensor by
measuring the heart rate. If
there is no reading, replace
the sensor cable with a new
one
2. Move the sensor cable in
the frame. If there is no
reading, replace the sensor
cable and the LCD panel
with a new one
1. Level the device
ground 1. Check the surface on
which the device is placed
2. Loosen the mounts and oil
them. Fasten with sufficient
pressure