Functional Description - Milwaukee 2848-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

6
5
4
3
2
1
19
18
1. Memory button
2. Overload indicator
3. Units button
4. Power button
5. Temperature protection
indicator
6. Reached target
indicator
7. Manual inflate
8. Target input value
9. Actual value
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
8
7
UNITS
MEMORY
12
13
15
14
16
17
10. Units
11. Inflation button
12. Digital pressure
gauge
13. - / + buttons
14. Handle
15. Hose
16. Schrader chuck
17. Sports needle
18. Inflator nozzle
19. Presta valve
WARNING
may be hazardous.
10
Setting the Units (
To select desired unit of pressure, press and hold
the units buttons. Repeat until the desired unit is
displayed (PSI, kPa, or BAR).
During extended use or constricted air flow, the tool
temperature may rise. If the Temperature Protection
Indicator
10 minutes before continuing. In extremely low tem-
peratures, the Temperature Protection Indicator
11 may come on if the battery is too cold.
NOTICE: To avoid tool damage from overheating,
allow tool to cool for 40 minutes after each 20 minutes
of continuous use.
Auto Pressure Check Feature
The inflator will pause at the end of a fill for the pressure
to stabilize and then check the system pressure.
After checking the system pressure, if the target PSI has
not been reached, it will continue to inflate to achieve
the most accurate results.
The Auto Pressure Check feature may occur up to 5
times. Once the target PSI is achieved, the inflator will
Auto Shut Off to prevent overinflation.
If airflow is constricted during use, the Overload
Protection Indicator
connections for blockages before continuing use.
Accessories/Hose Storage
Accessories provided with the inflator can be stored
on the back of the tool. The hose can be wrapped
around the storage area and secured in the hose
clamp.
WARNING
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Do not leave the tool unattended during operation.
Risk of Bursting. Do not overinflate. Follow all
manufacturer's instructions for the item.
1. Place the tool on flat surface.
2. Insert the proper accessory on the inflator.
3. Attach the item to be inflated.
• Always attach the inflator to desired object before
starting inflation.
• No accessory is needed for common car/truck
tire schrader valves.
• For car/truck tires, screw schrader chuck onto
tire valve and ensure it is tight.
4. Insert the battery pack.
5. To turn on, press the Power
will detect the current air pressure of the item.
6. Use the
sure, if desired. Press and hold
to set target pressure quicker.
NOTE: Setting target pressure is not recom-
mended when using the accessory nozzles.
4
Only use accessories specifically
recommended for this tool. Others
PSI, kPa, or BAR
Temperature Protection
comes on, allow the tool to cool at least
Overload Protection
may come on. Check all
OPERATION
To reduce the risk of injury, always
wear proper eye protection marked
Using the Inflator
and buttons to set the target pres-
)
button. The tool
or buttons