DeLonghi PAC ES Serie Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
(C3) or
(C4) key.
Select the desired fan speed by pressing the
The speeds available are:
Minimum air flow: when maximum silent operation
is desired.
Maximum air flow: to reach the desired
temperature as soon as possible.
Auto air flow: The appliance automatically chooses
the best fan speed based on the temperature selected
and the environmental conditions.
The most suitable temperatures during the summer range from 24
to 27°C. However, setting the temperature significantly lower than
the outdoor temperature is not recommended.
DEHUMIDIFYING MODE
This is ideal for reducing humidity in the room (spring and au-
tumn, damp rooms, rainy periods, etc). For this type of use, the
appliance must be set up as for air conditioning mode. That is, the
air exhaust hose (B1) must be fitted to the appliance to allow the
humidity to be discharged outside.
To correctly set this mode:
Press repeatedly the MODE key (C2) until the dehumidify-
ing indicator (C10) appears.
The available air flow is:
Automatic air flow: the appliance automatically
sets the best ventilation speed according to the envi-
ronmental conditions.
Note: in case of high humidity in the environment, it is possible
to discharge the condensate continuously by connecting a suit-
able hose to the upper drain connection (A11), allowing the
water to flow into a container.
Make sure that the water does not overflow onto the floor and
that the drain hose is not blocked or folded (Fig. 4).
FAN MODE
(C5) key.
When using this mode, the air exhaust hose (B1) does not need
to be attached to the appliance.
To correctly set this mode:
Press repeatedly the MODE (C2) key until the fan indicator
lights on.
Pressing repeatedly the
flow is selected.
The available air flows are:
Minimum air flow: when most silent operation is
desired.
Maximum air flow: for maximum performance.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F. To change the tem-
perature unit of measure select the air conditioning mode then
press both the decrease
about 10 sec. The change of the unit of measurement is con-
firmed by an acoustic signal.
SETTING THE TIMER
The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
How to program delayed shut down
While the appliance is on in any operating mode, delayed
shut down can be programmed.
Press the Timer button (C6): the timer indicator (C8) and
hours light up.
Use buttons
after which the appliance should shut down.
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer indicator stays
lit.
At the pre-set time, the air conditioner goes into Standby.
14
(C5) key till the desired air
(C3) and increase
(C3) or
(C4) to set the number of hours
(C4) keys for

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pac es72 youngPac es72 classicPac es72

Tabla de contenido