Durati Battery-Operated Shearing Machine; Intended Use, Charger Xt433 / Li-Ion Battery Xt431; Durati Battery-Powered Shearing Machine Functionality; Functionality, Charger Xt433 / Li-Ion Battery Xt431 - B.Braun Aesculap Suhl DURATI Instrucciones De Manejo/Descripción Técnica

3.3 DURATI battery-operated shearing
machine
Note
The device is intended only for cut-
ting human and animal hair.
The battery-operated DURATI shearing machine is used
for shearing people and small animals.
The DURATI battery powered shearing machine must
be used with a shearing head to be selected according
to the respective application.
3.4 Intended use, charger XT433 / Li-
ion battery XT431
The charger XT433 is used for charging the DURATI
battery-powered shearing machine and the Li-ion bat-
tery. There is one charging bay each for the two com-
ponents.
3.5 DURATI battery-powered shearing
machine functionality
The DURATI battery-powered shearing machine is
switched on (off) by pushing the ON/OFF switch up
(down).
3.6 Functionality, charger XT433 / Li-
ion battery XT431
The XT433 charger is designed for a mains voltage
range from 100 V to 240 V and from 50 Hz to 60 Hz.
To make the charger XT433 ready for operation, con-
nect it to mains power by plugging in the mains plug.
The charger XT433 is equipped with two charging bays.
The first charging bay is for charging the DURATI bat-
tery-powered shearing machine, while the Li-ion bat-
tery is charged in the second charging bay.
Each charging bay has an indicator field on the charger
front panel assigned to it.
Charging starts automatically, as soon as a Li-ion bat-
tery is inserted in the charging station.
The charging time in the charging bays depends on the
charge state and capacity of the Li-ion batteries.

3.6.1 Charging principle

The Li-ion batteries are charged by constant current
pulses.
The charge state of the Li-ion battery is monitored
during charging. Monitoring of the charging curve
ensures that the battery is fully charged without over-
charging.
Additionally, the battery temperature and charging
time are monitored as well.
Only charging bay is active at a time. The machine
(front charging bay) is always charged first. It is then
first examined whether a battery is inserted in the rear
charging bay. If this is the case, the battery is charged.
If a battery is inserted into the rear charging bay while
a machine is being charged in the front charging bay,
the LED for the rear charging bay blinks green once
(battery detected) and then goes out until the battery
of the machine in the front charging bay is charged.
Only then does the charging process for the battery in
the rear charging bay start.
The charger monitors the battery status and indicates
the charge state via two LED indicators.
LED indicators:
• Blinking green: battery charging
• Illuminated green = battery is completely charged
• Blinking red = battery or charging station defective
Have the manufacturer repair the product.

3.6.2 Charging time

Charging is stopped as soon as the maximum charging
time is reached.
The charging time is approx. 240 min.
4.

Preparation and setup

Non-compliance with these rules will result in com-
plete exclusion of liability on the part of Aesculap.
When setting up and operating the product, adhere
to:
– national regulations for installation and opera-
tion,
5