Working With The Durati Battery-Powered Shearing Machine And Charger Xt433/Li-Ion Battery Xt431; System Set-Up; Connecting The Accessories; Attaching The Blade - B.Braun Aesculap Suhl DURATI Instrucciones De Manejo/Descripción Técnica

Aesculap Suhl GmbH
DURATI battery-powered shearing machine
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
CAUTION
Do not cover the ventilation
slots of the product.
Connect the product to power
mains with a voltage range of
100 V to 240 V and a frequency
range of 50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
5. Working with the DURATI
battery-powered shearing
machine and charger XT433/
Li-ion battery XT431

5.1 System set-up

5.1.1 Connecting the accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
6

5.1.2 Attaching the Blade

Risk of injury caused by sharp cut-
ting plates!
Handle the shearing head of the
DURATI shearing machine care-
WARNING
fully.
Note
The shearing head GT330 #10 for the DURATI battery-
powered shearing machine is included in the scope of
delivery. Various shearing heads are available for dif-
ferent applications!
17
Fig. 1
If knife hinge is closed: Open knife hinge 17 with
screwdriver, see Fig. 1.
12
Fig. 2
17