Basics; Remote Control (Rm-Rk52); Getting Started; Acknowledge The Crossover Type And Cancel The Demonstration - JVC KD-T925BTS Manual De Instrucciones

Basics

Remote control (RM-RK52)

This unit can be remotely controlled with an optionally purchased remote
control.
Remote sensor (Do not expose to bright sunlight.)
Pull out the insulation sheet
when using for the first time.
How to replace the battery
To On the remote control
Adjust the volume Press VOL + or VOL – .
• Press and hold VOL + to continuously increase
the volume to 15.
Press d to mute the sound or pause playback.
• Press again to cancel. The volume level returns to
the previous level before muting or pause.
Select a source Press SOURCE repeatedly.
(for KD-T925BTS/KD-T920BTS)

Getting Started

1
Acknowledge the crossover type and cancel the
demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 6), the display shows: "2-WAY X'OVER" or "3-WAY X'OVER"
"PRESS" "VOLUME KNOB" "TO CONFIRM".
1
Press the volume knob to acknowledge the current crossover type.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB".
• To change the crossover type, see page 27.
2
Press the volume knob.
[YES] is selected for the initial setup.
3
Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
To adjust the clock
3 Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Set the time in the order of "Hour" "Minute".
5
Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
5
ENGLISH