DJI LiDAR Guia Del Usuario página 8

Swipe right from the left of the touchscreen to enter the LiDAR page. Tap the icon
on the bottom right corner of the touchscreen to enter LiDAR settings.
3. Tap Lens profile. Tap + and tap Set, then tap +/- or drag the bar to input focal
length.
4. Tap < and then tap Start Motor Calibration. The focus motor will begin to rotate
when calibrating. Tap Confirm when the calibration is complete.
5. Power on the attached camera before calibrating the lens. Focus on a subject in
the center of the camera view that is approx. 1 m (0.7 m to 1.2 m) away. A white
box will appear on the subject. Check if the subject is in focus on the attached
camera view (not the touchscreen). Adjust the front dial of the gimbal until the
subject is in focus and tap Confirm.
Repeat the previous step with a subject that is approx. 4 m (3.5 m to 4.7 m)
away.
Lens profile is complete after the lens calibration has been completed. DJI RS 3 Pro
supports up to three lens profiles. The indicator light of C1, C2, and C3 turn on to
indicate which lens profile is applied.
For the existing lens profile, delete the lens profile and recalibrate the lens if autofocus
is inaccurate. Motor calibration is needed if the endpoint of the focus motor is
changed due to the mounting position being changed. Tap Motor Calibration or press
the Function button twice to start calibration.
Lens Profile
Set
Focal length
Start Motor Calibration
Lens Profile
24mm
Focal Lengh
Start Motor Calibration
1m 1m
Focus on object 1 m away
and rotate front dial
LiDAR Settings
Lens Profile
Installation Distance
75mm
AF Tracking Sensibility
3D TOF function
Focal Length
24mm
1m 1m
Make sure the subject
within focus point is clear
7