ARGENTO Alpha Manual De Instrucciones página 13

Front mudguard installation
Remove the front light fixing screw located in the front part of the fork to allow the fender bracket to be inserted; secure the
fender together with the front light to the top of the fork using the previously removed screw.
Subsequently (also after installing the front wheel), secure the side supports of the front fender to the corresponding fork
stems by removing, and subsequently inserting, the screws on them (right and left side) taking care to screw them gradually
and alternately until tightened.
Front wheel installation
Insert the front wheel into the appropriate fork housings (forks) and tighten with the appropriate quick release device (fig. A).
Lever Pin Locking nut
Conical springs*
fig. A
*Conical springs: position the end of the conical springs (those with the smallest diameter) in the direction of the wheel.
Insert the pin equipped with the relative conical spring inside the hub, leaving the lever on the right side of the bicycle
(side without the brake disc); insert the second conical spring and the locking nut into the pin coming out of the hub on the
opposite side (side equipped with the brake disc), screwing it until flush against the dropout
Close the lever towards the fork to complete the tightening operation by verifying that the lever has adequate resistance
during the closing phase (such as to leave a mark on the palm of the hand used to tighten the lever, so-called "imprint on
palm") and, after closing, requires a considerable force to be exerted to allow relative opening.
The following image shows the complete installation of the mudguard and front wheel on the product.
12