4 I English
1
TECHNICaL DaTa
Type
Dimensions mm
Weight kg (without fasteners)
Single sequential or contact actuation
Switchable
Recommended operating pressure
range
Maximun permissible operating
pressure
air consumption per driving
operation
Magazine capacity No. of fasteners
Penetration depth setting
Fastener: Plastic bound nail
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2
NoISE/VIBRaTIoN INfoRMaTIoN
Noise characteristic values *
a-weighted single-event emission
sound pressure level at work
station L pa, 1s
a-weighted sound power level
L Wa, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a),
a h, w, 3s
The noise level when working can exceed 85
dB (a). Wear ear protection!
*
Measured values determined according to
EN 12549:2008.
** Measured values determined according to
ISo 8662-11:2001.
3
SUPPLIED WITH
1
Strip magazine Nailer
1
Tool use and safety instructions
1
Technical data sheet
Karl M. Reich Verbindungstechnik GmbH
4
3555
Only those fasteners specified under technical data
(see 1) may be used.
529/369
When filling the magazine, hold the tool so that the
3,6 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
yoke or trigger depressed.
6 - 8 bar/0,6 -
Pull pusher (l) back until it has reached the point
0,8 MPa
where there is noticeable resistance and it catches.
8 bar /
Introduce 2 nail strips into the magazine (m), unlock
0,8 MPa
pusher and lead it against the nail strip. Make sure that
3,1 l at 6
the nail strips lie correctly in the magazine and that
bar / 0,6 MPa
the pusher nose reaches over the head of the last nail.
Never should the pusher be allowed to snap forward
56-70
in a magazine which is half or totally empty. always
yes
guide it by hand up to the nail strip or stop.
50-100
5
2,8-3,8
-SINGLE TRIGGER RELEaSE/RELEaSE oN CoNTaCT-
a setting wheel on the trigger (s) can be turned to set
9 4420
the type of actuation either to single trigger release
68 3868
or release on contact (see symbol).
6
3555
The penetration depth of the nail head can be
controlled by means of the air pressure. If this is
not satisfactory, the penetration setting offers a
more accurate adjustment of the penetration depth.
91 dB(A)
adjustment is only possible in the unpressurized
condition.
104 dB(A)
The penetration depth setting can be moved by one
or more notches by loosening the screw (n) and the
safety yoke (a). for safety reasons, this should only
be carried out in a depressurised state.
5,17 m/s2
Retighten the screw.
7
Balancer for 30-55 N (3.0-5.5 Kp),
cable travel 2.0 m (6.5 ft)
fILLING THE MaGazINE
SWITCHaBLE aCTUaTIoN
fIL PENETRaTIoN DEPTH SETTING
aCCESSoRIES
3555
Code No.
28 6478
REICH ®