Michele RONDA 703 Manual De Instrucciones página 6

CHRONOGRAPH MODELS (ETA G10, G15)
Hour Hand
Second Hand
Setting the Time
1. Pull crown out to position III (the watch stops).
2. Turn crown until you reach correct time.
3. Push crown back into position I.
Setting the Date
1. Pull crown out to position II (the watch continues to run).
2. Turn crown until yesterday's date appears.
3. Pull crown out to position III (the watch stops).
4. Turn crown until correct date appears.
5. Continue to turn crown until correct time appears.
6. Push crown back into position I.
10
Minute Hand
Pusher A
I II III
Crown
(Position I, II, III)
Pusher B
Date Indicator
Chronograph
• The minute counter measures 30 minutes per rotation.
• The center stop-second measures 60 seconds per rotation.
Center Stop-second
Minutes Counter
PLEASE NOTE:
Before using the chronograph functions, please ensure that:
- the crown is in position I (= normal position).
- the three chronograph hands are precisely at zero position following activation of pusher
B. Should this not be the case, the positions of the hands must be adjusted (see chapter
entitled "Adjusting the chronograph hands to zero").
Chronograph: Basic Function
(Start / Stop / Reset)
1. Press pusher A to start the center stop-second hand.
2. To stop the timing, press pusher A again.
3. To reset the three chronograph hands to zero positioning, press pusher B.
1/10 Second Counter
Pusher A
I II III
Crown
(Position I, II, III)
Pusher B
11