Tabla de contenido
Publicidad
c) Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have
the power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
f) Use the power tool, accessories and tool bits
etc., in accordance with these instructions
and in the manner intended for the particular
type of power tool, taking into account
the working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) Service
Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
It is essential to read and understand the general
safety instructions!
Never put fingers, your face, hair or other parts
of the body, or loose, wide items of clothing into
the operating and intake areas of rotating parts
(workpiece, clamping chuck, centering chuck). Do
not wear jewelery (rings, chains etc.). Risk of injury
and accidents!
In the event of faults (unusual smell, vibrations,
and unusual noises) during work with the COLLINS
CLASSIC 22A, it is essential to immediately press the
safety pedal and perform an EMERGENCY STOP of
the machine!
If the machine is running, it is prohibited to hold the
workpieces manually or to perform similar work, and
to fit and remove parts such as filters, valves, pipe
sections etc!
Wear safety clothing! Wear a safety mask to provide
protection against splashes of thread oil as well as
any chlorine gas vapors (from thread oil burning on
hot tool and workpiece surfaces)! Wear a safety hat
to cover and protect long hair. Wear safety gloves
when changing the thread jaws, the pipe cutting
wheel and the pipe deburrer. Wear safety gloves
when changing the tool and workpiece. The thread
and thread cutting dies get hot during threading!
Phone 800-545-7698 • FAX 815-633-0879 • www.rothenberger-usa.com
ROTHENBERGER USA – CLASSIC 22A
Wear safety footwear. Risk of injury from wet,
slippery and possibly off-center machine parts when
changing the tool!
Do not remove metal and plastic chips using
compressed air! There is a risk of eye injuries and loss
of eyesight!
Ensure sufficient ventilation during indoor use
(closed rooms). The permissible ambient temperature
is between 0°C and 40°C / 32º and 104º!
Before changing the cutting heads, the cutting
wheel, the pipe deburrer, always switch off the
machine and disconnect power.
After it has been switched off, the machine still
coasts for a while until it comes to a standstill.
Do not touch any parts before the machine is
completely stationary and the electrical plug has
been pulled out!
In the case of the threaded pipes, carry out a
pressure test in order to ensure that no gas or water
can escape after the pipes are fitted!
3
ENGLISH
Publicidad
Tabla de contenido
