GET ECULMB Guia De Instalacion página 10

E. ZERO TPS CALIBRATION
Zero TPS Calibration allows GET ECULMB to properly recognize
when the throttle is completely closed, and to ensure accurate
readings of the fuel level injected into the combustion chamber.
When installing a new control unit or other accessories, GET
recommends carrying out the Zero TPS Calibration. This
calibration will ensure a correct fuel calculation, so the motorbike
can accelerate accurately, and it will avoid poor fuel economy.
ATTENTION: The minimum value is saved if similar to
the OE one, otherwise GET ECULMB will discard the
value because it will read it as incorrect. It is possible
to manage the maximum value only with GET Maya
software.
It is possible to carry out the ZERO TPS Calibration with or
without GET WiFi-COM (included in the kit) or with GET Maya
software (sold separately).
REMEMBER TO WORK UNDER SAFETY CONDITIONS AND
TO KEEP THE ENGINE TURNED OFF.
ZERO TPS CALIBRATION – with GET WiFi-COM
To set Zero TPS, open WiGET app
and select "MONITOR" section.
Follow the instruction in GET
WiFi-COM manual, included in the
kit, and look at WiGET video tutorial
(minute 5:55). Scan the QR code.
EN
10