General Warnings - GET ECULMB Guia De Instalacion

ENGLISH
A. WARNINGS FOR CORRECT USE
Read all the instructions and warnings carefully before using
GET Eculmb Race Kit. Failure to read and/or observe the
instructions and warnings can lead to incorrect use of the
device or its malfunction, resulting in product damage and
personal injuries.
GET ECULMB IS INTENDED ONLY AND EXCLUSIVELY
FOR RACING USE.

GENERAL WARNINGS

1. Follow the instructions described in this manual to prevent
vehicle damages.
2. Do not modify or replace the material supplied by GET.
3. Always make sure that no installed part can interfere with
the hot parts of the engine, the steering components or with
the rider.
4. The product is not a toy. Keep it out of the reach of children
and/or animals as it contains small sized components that
could be swallowed.
5. Do not use the product for purposes other than those
specified in these instructions.
6. Do not use high pressure washers on the product.
SPECIFIC WARNINGS
After installing GET control unit, for the first startup it
is mandatory to turn the key of the main switch into ON
position without starting the engine, and then turning
the key into OFF position to switch off the dashboard.
Wait 10 seconds before starting the engine. This
procedure is for resetting the position of the idle control
valve. If this procedure is not carried out, the vehicle may
experience a difficult starting or not starting at all.
EN
2